Product Overview and Specifications
Safety Information 1
1-7
Safety Information
A Warning identifies conditions and procedures that are dangerous to the user. A
Caution identifies conditions and procedures that can cause damage to the Product or
the equipment under test.
See Table 1-3 for a list of symbols used in this manual and on the Product.
Table 1-3. Symbols
Symbol Description Symbol Description
W
Risk of danger. Important
information. See manual.
AC (Alternating Current)
X
Hazardous voltage. Voltage
>30 V dc or ac peak might be
present.
DC (Direct Current)
or
AC or DC (Alternating or Direct
Current)
Digital signal.
Earth ground.
+
Power ON / OFF
Recycle.
T
Double insulated.
CAT II
Measurement Category II is
applicable to test and measuring
circuits connected directly to
utilization points (socket outlets
and similar points) of the low-
voltage MAINS installation.
CAT III
Measurement Category III is applicable to
test and measuring circuits connected to the
distribution part of the building’s low-voltage
MAINS installation.
CAT IV
Measurement Category IV is
applicable to test and measuring
circuits connected at the source
of the building’s low-voltage
MAINS installation.
P
Product conforms with the requirements of
the applicable EC directives.
~
This product complies with the
WEEE Directive (2002/96/EC)
marking requirements. The
affixed label indicates that you
must not discard this
electrical/electronic product in
domestic household waste.
Product Category: With reference
to the equipment types in the
WEEE Directive Annex I, this
product is classed as category 9
"Monitoring and Control
Instrumentation” product. Do not
dispose of this product as
unsorted municipal waste.
Ã
Conforms to relevant South Korean EMC
Standards.
1.888.475.5235info@Fluke-Direct.com
Fluke-Direct.com
To Next Page
Loading...
