5790B
Operators Manual
6-12
Table 6-6. Command Summary (cont.)
Instrument Configuration Commands
ADDR Sets the GPIB address.
ADDR? Returns the GPIB address.
BRIGHTNESS Sets the brightness of the GUI display.
BRIGHTNESS? Returns the brightness setting.
AMPS? Returns the corrected current shunt equivalent given the selected shunt.
AMPS_DELTA?
Return the shunt-corrected difference/ratio between the measurement and the
reference.
AMPS_PKPK?
Returns the corrected current shunt peak-to-peak equivalent given the selected
shunt value.
AMPS_REF? Returns the reference value against which shunt-corrected DELTAs are computed.
CAL_MODE? Returns the setting of the CALIBRATION MODE state.
CAL_SW? Returns the setting of the CALIBRATION security state.
CLOCK Sets the real time clock/calendar
CLOCK? Queries the value of the real time clock/calendar
COMM Selects the remote interface
DATEFMT Selects the clock/calendar date format
DATEFMT? Returns the clock/calendar date format.
DHCP Turns on/off DHCP.
DHCP? Returns the state of the DHCP setting.
EMULATE Partially emulates a 5790A over the remote interface.
EMULATE? Returns the state of emulation as set by the EMULATE command.
ENETPORT Sets Ethernet port.
ENETPORT? Returns the Ethernet port setting.
EOL Sets EOL for given port.
EOL? Returns EOL for given port.
EOFSTR Stores the end of file character sequence for use in cal reports.
EOFSTR? Returns the end of file character sequence set for cal reports.
EXTGUARD Sets external guard.
EXTGUARD? Returns the setting of external guard.
EXTRIG Selects single trigger mode.
EXTRIG? Returns the setting of EXTRIG.
FIRSTIN Stores the power-up configuration for the initial input.
FIRSTIN? Returns the power-up configuration for the initial input.
To Next Page
Loading...
