Fluke 5790B - Page 119

Remote Commands
Alphabetical List of 5790B Device-Dependent Commands 6
6-29
CAL_DATE
This sets the verification date to the date returned by the internal clock/calendar;
the calibration mode must be unsecured.
Parameter
None
CAL_DATE?
Returns the date of the most recent verification or calibration.
Parameters
No argument (Returns the date of the most recent verification, as set by
CAL_DATE)
ZERO (Returns the date of the most recent zero calibration)
MAIN (Returns the date of the most recent main input adjustment)
WBND (Returns the date of the most recent Wideband input
adjustment)
SERVICE (Returns the date of the most recent Service adjustment)
CAL_DATE? also emulates 5790A syntax with two parameters:
1. ACTIVE, STORED, or OLD (which set the date comes from)
2. One of the following keywords:
DC (Returns the specified date of DC adjustment)
AC (Returns the specified date of AC adjustment)
ZC (Returns the specified date of zero calibration)
WDC (Returns the specified date of Wideband gain adjustment)
WAC (Returns the specified date of Wideband flatness
adjustment)
ALL (Returns the specified date of calibration)
Response
(Integer) Date in the format defined by the DATEFMT command (or in the
utility menus).