Users Manual
Setting Up the Tester
11
Figure 3. Bond Zero Connections
DISPLAY EXPLANATION
BOND
ZERO
The earth bond test lead zeroing function
has been selected.
seconds
The test time is counted down
Ω
Zeroing completed, the tester shows the
resistance value of the test lead (zero
value). It will subtract this value from the
bond test results.
>
Ω
The lead resistance is higher than 1.99 Ω ,
it cannot be compensated for. The zero
value is set to the factory default of 0 Ω
now. Earth Bond test will be locked out.
The tester saves the zero value so you will not need to
repeat the operation every time you use the tester.
If the Earth Bond test has been zeroed, the idle screen
and subsequent earth bond test results will be marked
with ∅, for example:
∅
Ω
To Next Page
Loading...
