6200
Users Manual
28
Printing Test Results
The print function prints all the stored results from the
earliest to the latest using the optional Fluke SP1000 mini
printer. Printing is disabled when any appliance test is
running.
To print the results, do the following:
1
Connect the printer to the tester RS232 port.
2
PRINT
Start printing, the display shows the
progress, see the table below.
DISPLAY EXPLANATION
MULTI RESULTS
PRINT
The printer is connected and turned on.
All records will be printed
Record 12 is in progress.
PRINT Printing has finished or there are no
results in the memory, the display reverts
to the idle screen.
If the beeper sounds, and the
icon is turned off when
you press
PRINT
, the tester could not detect the printer.
In this case also the idle screen will not show the
icon.
If printing fails, do the following:
• verify that the Fluke SP1000 mini printer is connected
to the tester and that the printer power is on.
• verify that you use the correct cable.
• Verify that the printer dip-switch settings are in the
default position (see Fluke SP1000 mini printer user
Guide).
Note:
The interface cable must be equipped with 9 pin
plugs on both ends and wired in a pin to pin
configuration. Please use the cable supplied with
the Fluke SP1000 mini printer.
To Next Page
Loading...
