Fluke 6200 - Saving Test Results; Clearing the Store

Users Manual
Using the Memory
27
Saving Test Results
Warning
In continuous test mode the test continues
whilst you are saving the result!
To save a test result, do the following:
1
MEM
The actual test result is saved into memory.
The display shows the number that has been assigned to
the record for 2 seconds, for example memory , then:
• it reverts to the idle screen if a test was finished.
• in the continuous test mode, it shows the next result.
If you press
MEM
again while the record number is
being displayed, the result will not be stored.
If you store a result in the continuous test mode while the
test is running, the displayed result is stored without
interrupting the test.
If you press
MEM
in the continuous test mode before a
new result is available, the display shows memory and
the beeper sounds twice.
If the result cannot be saved as the store is full, you must
clear the store, repeat the test and then store the result.
Clearing the Store
The clear function clears all memory locations. It is
disabled when any appliance test is running.
Print the results before clearing the store if you want to
preserve the results.
To clear the memory, do the following:
1
CLEAR
Hold down the button for more than 5
seconds, the display shows the progress,
see the table below.
DISPLAY EXPLANATION
CLEAR?
seconds
A delay period is counted down. To
prevent the clear action release the
button within this period.
CLEAR?
The store is being cleared.
CLEAR? The store is empty, the display reverts to
the idle screen.
If a double beep sounds when this
message is shown, the clear action has
not started.