Fluke 702 - Page 18

Documenting Process Calibrator
Introduction
7
The accessories listed below and shown in Figure 2
are available from Fluke:
• Pressure Modules, Fluke model numbers listed
below. (Differential models also operate in gage
mode.)
700P01: 0 to 10 inches of H
2
O, or 2.5 kPa
(differential nonisolated)
700P02: 0 to 1 psi (differential, nonisolated)
700P03: 0 to 5 psi (differential, nonisolated)
700P04: 0 to 15 psi (differential, nonisolated)
700P22: 0 to 1 psi (differential, isolated)
700P23: 0 to 5 psi (differential, isolated)
700P24: 0 to 15 psi (differential, isolated)
700P05: 0 to 30 psi (gage, isolated)
700P06: 0 to 100 psi (gage, isolated)
700P07: 0 to 500 psi (gage, isolated)
700P08: 0 to 1000 psi (gage, isolated)
700P29: 0 to 3000 psi (gage, isolated)
700P30: 0 to 5000 psi (gage, isolated)
700P31: 0 to 10000 psi (gage, isolated)
• Model BE9005 Series Battery Eliminator for
bench-top use.
• PMLink software and cable for developing
procedures and transferring procedures and
data (for Model 702 only).
• Model BP7217 Nickel-Cadmium battery pack.
• Service Kit.
• C700 Carrying Case.