Fluke 702 - Measuring Electrical Parameters

701/702
Users Manual
28
If the range is locked, overrange inputs produce a
display of - - - - - -. In Auto Range, out of range
inputs produce a display of ! ! ! ! ! !.
Measuring Electrical Parameters
When you turn on the calibrator, it powers up in the
dc voltage measurement function. To select an
electrical measurement function from either
SOURCE or MEASURE/SOURCE mode, first press
M for MEASURE mode, then proceed as follows:
1. Press M for current, v for dc voltage, h
once for ac voltage or twice for frequency, or
q for resistance.
NOTE
To measure frequency you are prompted to
select a frequency range as shown next. If
you expect the frequency you are measuring
to be below 20 Hz, press
d to select the
lower frequency range, then press
e .
2. Connect the test leads as shown in Figure 9,
depending on the measurement function.