Fluke 702 - Using the Backlight

Documenting Process Calibrator
Setting Up the Calibrator
25
3. Use the u and dkeys to move the cursor to
the parameter you want to change, then press
e or the Choices softkey to choose a
setting for that parameter. For example, the
following display appears after you select Date
Format:
4. Press uor d to move the cursor to the desired
date format.
5. Press e to go back to the s display.
6. Make another selection or press the Done
softkey or s to save your settings and exit
s mode.
Using the Backlight
Press C to turn on the display backlight. Press C
again to turn it off. When the backlight is on, the
G symbol shows at the top of the display. If desired,
you can minimize battery usage by setting the
calibrator to turn the display backlight off
automatically. When the backlight is turned on and