Fluke 702 - Personalizing the Calibrator

701/702
Users Manual
26
Auto Backlight Off is activated, the asymbol shows
at the top of the display. To automatically turn off the
backlight after a set time, proceed as follows:
1. Press s.
2. Press d to highlight Off following Auto
Backlight Off.
3. Press e or the Choices softkey.
4. Press u to highlight On, then press e.
5. To accept the timeout period shown on the
display, you can finish here. Press Done to exit
s mode and do not go on to step 6.
6. To change the timeout period, press d to
highlight the timeout period following Backlight
Timeout.
7. Press e or the Choices softkey.
8. Enter your choice of timeout period in minutes
(accepted range: 1 to 120 minutes).
9. Press the Done softkey.
10. Press the Done softkey or s to exit s
mode.
Personalizing the Calibrator
You can load your name or some another
alphanumeric identifier into the calibrator for display
at power-up and in saved results. Proceed as follows
to load an identifier:
1. Press s
2. Press Next Page twice.
3. Press d to move the cursor to the same line as
ID.
4. Press e or the Choices softkey. The
display appears as follows: