701/702
Users Manual
52
Simulating RTDs
NOTE
Refer to Table 6 for information about RTD
(Resistance Temperature Detector) types
supported by the calibrator.
Connect the calibrator to the instrument under test as
shown in Figure 19. Proceed as follows to simulate
an RTD (Resistance Temperature Detector):
1. If necessary, press M for SOURCE mode.
2. Press tuntil the select RTD type display is
showing.
3. Press the u or d keys followed by e to
select the desired RTD type.
4. Enter the temperature you want to simulate as
prompted by the display, then press e.
To Next Page
Loading...
