Fluke 709 - The Product; The Buttons

709/709H
Users Manual
8
The Product
The subsequent sections are about the features and
functions of the Product.
The Buttons
Figure 2 and Table 3 show the location and brief
descriptions of the Product buttons.
gzx001.eps
Figure 2. Buttons
Table 3. Buttons
Button Function

Push to enable step or ramp.

Push to turn on or turn off the backlight.

Push to turn on and turn off the Product.

Push to set the output to 20 mA when in mA
Source or mA Simulate modes. In
Measurement mode the button does not set
the output current.

Push to step the output up or down by 25 %
increments (4, 8, 12, 16, 20 mA).

Push to set the output to 4 mA when in
mA Source or mA Simulate mode. In
Measurement mode the button does not set
the output current

Push to enter the Main menu. Push a
second time to exit the Main menu. See the
“Main Menu” section.