709/709H
Users Manual
34
4. Push to go to the Function Select menu. A
reminder to change the loop to AUTOMATIC is
shown first.
Write URV
The Product warns you to change the loop to MANUAL
before you proceed. Push the selection knob to proceed.
Push to go to the LRV and URV menu.
The present URV value and units are shown. See
Figure 34.
gzx43.eps
Figure 34. Write URV Screen
1. Push the selection knob to move the decade cursor.
2. Turn the selection knob to increment or decrement
the value in steps indicated by the selected decade.
3. Push and hold the knob to send the new value to the
HART device, remaining on this display. An error is
shown if the HART device rejects the value.
4. Push to go to the LRV and URV menu. A prompt
to change the loop to AUTOMATIC is shown first.
Trim, Set, and Zero Menu
Note
For the screens in this section, tag names can
be truncated to fit on one line if necessary.
flashes in the upper-right corner to show a live
connection.
If the HART write commands are not enabled, these
functions are not available and an error message is
shown instead of the screen shown in Figure 35.
gzx44.eps
Figure 35. Trim, Set, and Zero Screen
To Next Page
Loading...
