Precision Loop Calibrator
The Product
15
To use mA Measure with 24 V:
1. Select mA Measure with 24 V from the Main menu.
Once selected, the Product changes to the mA
Measure with 24 V home screen.
250Ω is shown in the lower right corner when the HART
resistor has been enabled on the setup menu.
Volts Measure
In the Volts Measure mode, the Product shows the loop
voltage. Figure 8 shows the Volts Measure home screen
and typical connections for this mode.
To use the Volts Measure mode:
Select Volts Measure from the Main menu. Once
selected, the Product changes to the Volts Measure
home screen.
Voltage
Output Device
gzx007.eps
Figure 8. Volts Measure Connections
To Next Page
Loading...
