Precision Loop Calibrator
The Product
13
mA Measure
In the mA Measure mode, the Product shows the loop
current measurement. This mode is without 24 V.
Figure 6 shows the mA Measure home screen and typical
connections for this mode.
To use mA Measure:
Select mA Measure from the Main menu. Once selected,
the Product changes to the mA Measure home screen.
250Ω is shown in the lower right corner when the HART
resistor has been enabled on the setup menu.
4 mA to 20 mA
4 mA-20 mA
Output Device
gzx005.eps
Figure 6. mA Measure Connections
To Next Page
Loading...
