Precision Loop Calibrator
Device Diagnostic
41
It is recommended that you use a Lemo to USB cable
with 709H/TRACK Software. It has a USB/Serial adapter
that uses an FTDI chipset. This combination gives
consistent and reliable communication between the
Product and PC. The USB Drivers are included on the
709H/TRACK Software CD.
Use the selection knob to highlight and select the correct
storage location.
Push to go to the Log Select menu.
When a storage position is selected, the menu in
Figure 44 is shown. Select the necessary action.
gzx53.eps
Figure 44. Configuration Log Showing Storage
Position
The number and contents of the storage position are
shown at the top. The tag number is <empty> if the
storage position is empty.
Use the selection knob to highlight and select the correct
function. Push to go to the Log Select menu.
SAVE operation:
• If the position is empty, save the present device
configuration data into the storage position.
• If the position is in use, confirm that the existing data
is to be replaced with the present tag data before you
save it into the storage position.
RECALL operation:
• If the position is empty, an error message is shown.
• If the position is in use, the data is shown in a
sequence of screens identical to the Device Data
screen.
ERASE operation:
• If the position is empty, an error message is shown.
• If the position is in use, confirm that the existing data
is to be permanently deleted before doing so.
To Next Page
Loading...
