Precision Loop Calibrator
Device Diagnostic
43
START operation:
• If no free records or free sessions remain, or the
present HART device does not match the HART
device already logged, an error message is shown.
• Otherwise, proceed to interval selection described
below.
ERASE operation:
• If there is no logged data, an error message is
shown.
• Otherwise, confirm that the present data is to be
permanently erased before doing so.
Select the logging interval. See Figure 46.
gzx55.eps
Figure 46. Logging Interval Screen
Turn the selection knob to move the highlight and select
the necessary interval. Push the selection knob to start
logging at that interval. Push to go to the first data log
screen.
While logging, the screen in Figure 47 is shown to
monitor progress.
gzx56.eps
Figure 47. Active Logging Screen
Push to stop logging and go to the first data log
screen.
To Next Page
Loading...
