Fluke 8050A - 600-1. Accessory Introduction; 600-3. Soft Carrying Case Y8205; 600-5. Ruggedized Carrying Case C86; 600-7. Rack Mounting Kits

600-1. INTRODUCTION
600-2. This subsection describes the basic use of the
accessories available for your 8050A.
For more detailed
information, refer to the instruction sheet included with
each accessory. When ordering an accessory, include its
model name and number.
600-3. SOFT CARRYING CASE Y8205
600-4. The Model Y8205 Soft Carrying Case (shown in
Figure
600-1) is designed for the storage and transport of
the 8050A. The case provides adequate protection against
normal handling and storage conditions. In addition to a
shoulder strap, the Y8205 includes a storage
compartment for test leads, power cord, and other
compact accessories.
Figure 600-1. Model Y8205 Carrying Case
Accessories
600-5. RUGGEDIZED CARRYING CASE C86
600-6. The Model C86 Ruggedized Carrying Case
(shown in Figure 600-2)
is a molded, polyethylene
carrying case designed to provide maximum protection
against rough handling
and adverse environmental
conditions. The C86 contains a separate storage
compartment for test leads, power cord, and other
compact accessories.
Figure 600-2. Model C86 Carrying Case
600-7. RACK MOUNTING KITS
600-8. Three rack mounting kits are available for
mounting your instrument in a standard 19-inch
equipment rack. The kits allow the 8050A to
be mounted
in the center, offset, or side-by-side (Dual)
in a standard
19-inch equipment rack.
600-9. Installation
600-10. Installation instructions for the rack mounting
kits are given in the following paragraphs.
600-1