Fluke ESA615 User Manual

ESA615
Users Manual
72
F1 - F2
gtv111.eps
Figure 39. Fuse Access
5. Use a multimeter to measure the continuity of each
fuse.
If a fuse does not show continuity, replace the fuse(s)
with a fuse of the same current and voltage rating.
Applicable fuse ratings are posted on the case bottom
label of the Product. Table 8 is a list of available fuses
with Fluke Biomedical part numbers.
6. Reinstall the fuse door and secure it with the screw.
How to Clean the Product
XW Warning
To prevent electric shock, do not clean the
Product plugged into mains or attached to a
DUT.
W Caution
Do not pour fluid onto the Product surface.
Fluid in the electrical circuitry can cause the
Product to fail.
W Caution
Do not use spray cleaners on the Product.
This can cause fluid to leak into the Product
and damage electronic components.
Clean the Product occasionally with a damp cloth and
weak detergent. Try to prevent the entrance of liquids.
Clean the adapter cables with the same precautions.
Examine them for damage and deterioration of the
insulation. Examine the connections for integrity before
each use.

Fluke ESA615 Specifications

General

Device Type	Electrical Safety Analyzer
Display	LCD
ECG Simulation	Yes
Respiration Simulation	Yes
Temperature Simulation	Yes
IBP Simulation	Yes
Defibrillator Synchronisation	Yes
Insulation Test Voltage	500 V
Mains Voltage	100 V to 240 V
Mains Frequency	50 Hz to 60 Hz
Leakage Current Tests	Earth Leakage, Enclosure Leakage, Patient Leakage
ECG Amplitude	0.5 mV to 5 mV
Voltage Range	Not Applicable
Current Range	0.1 mA to 20 A
Resistance Range	Not Applicable
Frequency Range	Not Applicable
Leakage Current Ranges	0.1 μA to 20 mA
Leakage Current Range	0.1 μA to 20 mA