ESA615
Users Manual
14
How to Set Up the Product
There are a number of Product parameters that are
adjusted through the setup function. To access the first
Setup menu shown in Figure 7, push Q.
gtv124.bmp
Figure 7. Setup Menu
Set the Operator Name
You can associate an operators name with electrical test
results. To set the operator name:
1. From the setup menu, push G or H until the
Operator name is highlighted.
2. Push e.
An operator list shows in the display. See Figure 8.
The Default User name “None” is used when an
actual user name is not set.
gtv123.jpg
Figure 8. Operator List Screen
Set the Operator Name from a List
1. From the Operator list, push G or H to highlight one
of the operator names.
2. Push e.
To Next Page
Loading...
