Fluke ESA615 - Delete an Operator Name

Electrical Safety Analyzer
How to Set Up the Product
15
Set a New Operator Name
1. From the Operator list, push the New softkey.
Note
The Product keeps a maximum of 20 operator
names. If you push the New softkey and there
are already 20 names, the Product will show an
error. You will have to delete one or more names
to add a new name.
2. In the keyboard screen, push E, F, G, or H to move
the highlight to a character.
3. Push e to add the highlighted character to the
name field.
Note
You can push the F2 softkey to set the keyboard
between upper and lower case letters. Highlight
àéîöç and push e to toggle between accent
characters and standard alpha-numeric letters.
4. Do steps 2 and 3 again until the operator name is
complete.
5. Push the Done softkey.
Note
Push the Backspace softkey to delete the last
character in the name field.
Delete an Operator Name
To delete an operator name:
1. From the setup menu, push G or H until the
Operator name is highlighted.
2. Push e.
3. From the Operator list, push G or H to highlight one
of the operator names.
4. Push the Delete softkey.
5. A delete confirmation screen will show in the display.
6. Push the Delete softkey.