Electrical Safety Analyzer
Test Sequences
69
Do a Test Sequence
To do a test sequence:
1. Push s to show the test sequence screen in
Figure 37.
gtv125.bmp
Figure 37. Test Sequence Screen
2. Push the Test Library softkey.
3. Push H or G to highlight a test sequence name.
Note
Push softkey F1 to toggle between an A to Z or Z
to A sort of the test sequences.
4. Push e.
Note
To see the details of the test sequence you are
about to start, push the Sequence Details
softkey.
5. Push the Start softkey.
The equipment information screen in Figure 38 shows
in the display.
gtv126.bmp
Figure 38. Equipment Information Screen
The number, serial number, manufacturer, model, and
location of the Device Under Test can be typed in to help
identify the DUT on the test results.
To Next Page
Loading...
