Fluke ESA615 - Make a Test Sequence from a Test Sequence in the Test Library

ESA615
Users Manual
68
Make a Test Sequence from a Test Sequence in the
Test Library
To make a test sequence from a test sequence already in
the test library:
1. Push s.
2. Push the Test Library softkey.
3. Push H or G to highlight a test sequence name.
Note
Push softkey F1 to toggle between an A to Z or Z
to A sort of the test sequences.
4. Push the View/Edit softkey.
5. Push the Save as New softkey.
6. Type in a new name with the screen keyboard.
7. Push the Done softkey.
The new test sequence steps are filled in with the
steps from the initial test sequence.
8. Push the Edit softkey.
Go through each setup step of the test sequence and
accept the parameters or change them for the new
test sequence.
9. Push the Save softkey to save the test sequence and
exit the wizard.
Edit a Test Sequence
To change one or more steps of a test sequence:
1. Push s.
2. Push the Test Library softkey.
3. Push H or G to highlight a test sequence name.
Note
Push softkey F1 to toggle between an A to Z or Z
to A sort of the test sequences.
4. Push the View/Edit softkey.
5. Push the Edit softkey.
You go through each step of the test sequence and accept
the step parameters or change them.