MicroScanner Series
Cable Verifiers
Users Manual
4
examples of this display. Disconnect the tester if it
detects high voltage.
•
Do not use the Product around explosive gas,
vapor, or in damp or wet environments.
•
Use this Product indoors only.
•
Do not connect the Product to voltages that are
higher than the maximum voltage rating for the
Product.
•
For Products that have multiple connectors for
different types of tests on copper cabling,
disconnect unused test leads from the
connectors before you do a test.
•
Use the Product only as specified, or the
protection supplied by the Product can be
compromised.
•
Do not use and disable the Product if it is
damaged.
•
Do not use the Product if it operates incorrectly.
•
Batteries contain hazardous chemicals that can
cause burns or explode. If exposure to chemicals
occurs, clean with water and get medical aid.
•
Remove the batteries if the Product is not used
for an extended period of time, or if stored in
temperatures above 50 °C. If the batteries are
not removed, battery leakage can damage the
Product.
•
The battery door must be closed and locked
before you operate the Product.
•
Repair the Product before use if the battery
leaks.
•
Replace the batteries when the low battery
indicator shows to prevent incorrect
measurements. (see "Battery Life, Status, and
Replacement" on page 54)
•
Turn off the Product and disconnect all test
leads, patch cords, and cables before you replace
the battery.
•
Be sure that the battery polarity is correct to
prevent battery leakage.
•
Do not disassemble or crush battery cells and
battery packs.
•
Do not operate the Product with covers removed
or the case open. Hazardous voltage exposure is
possible.
•
Remove the input signals before you clean the
Product.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
