Fluke MicroScanner MS-POE - Detecting Power Over Ethernet

Detecting Power Over Ethernet
37
Detecting Power Over Ethernet
To select PoE mode, press  or  until PoE appears on
the display.
In PoE mode, the tester solicits PoE on pairs 1,2-3,6 and 4,5-
7,8. The tester may activate a PoE source and will not be
damaged by PoE.
In twisted pair test mode, a flashing PoE mode indicator
means that PoE may be available. To verify the presence of
a PoE source, switch the tester to PoE mode.
Note
The tester will not detect PoE schemes that are not
compliant with the IEEE 802.3af standard, such as
Cisco
®
Inline Power.
MicroScanner
2
The MicroScanner
2
tester solicits and detects PoE voltage
from 802.3af sources. If PoE is detected,
appears above
the powered pairs. The
may blink as the PoE source
turns the power on and off.
Figure 27 shows the MicroScanner
2
display when the tester
detects PoE on pairs 4,5 and 7,8.
EGK30.EPS
Figure 27. MicroScanner
2
PoE Display
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com