Fluke MicroScanner MS-POE - Ethernet Port Detected

MicroScanner Series Cable Verifiers
Users Manual
24
Ethernet Port Detected
The tester can detect active and inactive Ethernet ports, as
shown in Figures 15 and 16.
Figure 15. Active Ethernet Port Detected
EGK13.EPS
 Ethernet port icon.
 Port speed for an active port:
• MicroScanner
2
: The speeds are 10, 100, or 1000
megabits per second.
• MicroScanner PoE: The speeds are 10, 100, 1000,
2500, 5000 or 10,000 megabits per second.
The figure shows 1000 megabits per second. If the port
supports multiple speeds the number cycles through
the speeds.
 Cable length. Dashes are shown if the tester cannot
measure the length. This can occur if the port does
not produce reflections.
Length may fluctuate or be obviously too high if the
port’s impedance fluctuates or varies from the cable’s
impedance. When in doubt, disconnect the cable from
the port to get an accurate length measurement.
C
A
B
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com