Fluke MicroScanner MS-POE - Analog Toner Mode (Optional Tone Probe Required)

MicroScanner Series Cable Verifiers
Users Manual
48
Analog Toner Mode (optional tone probe
required)
Refer to Figure 35.
1 Turn on the tester, then connect the tester to the cable.
2 MicroScanner
2
: Press  to select twisted pair or coaxial
cable.
3 Press  or  until  appears on the display (  );
then press
 or  to select an analog tone. The
display shows a scrolling sinewave in analog toner mode
(
 ).
4 To change songs, press  or. The display shows the
song number (
 ). The analog toner has four songs.
5 Use the probe to search for the cable.
EGK25.EPS
Figure 35. Analog Toner Mode Display
A
C
B
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com