Fluke MicroScanner MS-POE - Testing Coaxial Cabling

MicroScanner Series Cable Verifiers
Users Manual
34
Testing Coaxial Cabling (MicroScanner
2
)
1 Turn on the tester.
2 MicroScanner
2
: Press  to switch to coaxial test mode
(
).
3 Connect the tester and wiremap adapter or ID locator to
the cabling as shown in Figure 22.
For cabling not terminated with an F-connector, use an
adapter or hybrid patch cord to connect to the cabling.
The test runs continuously until you change modes or turn
the tester off.
EGK19.EPS
Figure 22. Connecting to Coaxial Cabling
(MicroScanner
2
)
Connection to
service
Coaxial patch cords
Wiremap
adapter
Wall
outlet
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com