MicroScanner Series
Cable Verifiers
Users Manual
46
Note
If you cannot locate the IntelliTone signal on
2-conductor cables, the cable may be shorted. Use
the tester to check for shorts. See pages 16 and 18.
6
Turn the probe’s rotary switch to (isolate).
7
Use the probe to isolate the tone source in the cable
bundle or at the patch panel. The SYNC LED lights up
green when the probe is receiving the IntelliTone signal.
The probe’s LEDs light up from 1 to 8 as the signal
strength increases. The higher the number, the stronger
the signal.
EGK07.EPS
Figure 33. IntelliTone Toner Mode Display
A
D
C
B
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
