Fluke QED 6 - Service, Calibration, and Battery Replacement; Packing and Shipping for Service

Maintenance, Service, and Calibration
Service and Calibration
3
3-5
Service and Calibration
If the new Analyzer fails to operate successfully or if it needs a recommended
yearly calibration, please contact the Fluke Biomedical Service Center
immediately, as indicated under Warranty and Product Support.
W Caution
To avoid damage to the Analyzer or adverse affects on its
performance, allow only qualified technical personnel to
service the Analyzer.
Battery Replacement
The replacement battery for the Analyzer is a standard 9 V alkaline battery.
XW Warning
To avoid possible electrical shock or personal injury,
disconnect all test leads and the ac adapter before
opening the battery door.
To replace the battery:
1. Disconnect all test leads and the ac adapter from the Analyzer.
2. Open the battery compartment door on the back panel.
3. Remove the battery, disconnecting it from the snap contacts.
4. Connect the 9 V alkaline replacement battery to the snap contacts.
5. Place the battery into the compartment and close the door until it clicks.
Packing
If repairs or calibration are required, return the Analyzer to the factory or the
nearest service center.
1. Before returning the Analyzer for factory service, contact Fluke
Biomedical Service Center for a required Return Authorization Number.
2. Provide the following information:
• The Analyzer serial number
• The specific steps that reproduce your problem