Fluke ScopeMeter 192B - Making Automatic Scope Measurements

Using The Scope
Making Automatic Scope Measurements
1
13
Making Automatic Scope Measurements
The test tool offers a wide range of automatic scope
measurements. You can display two numeric readings:
R
EADING 1 and READING 2. These readings are selectable
independently, and the measurements can be done on the
input A or input B waveform
To choose a frequency measurement for input A, do the
following:
1 Display the SCOPE key labels.
2 Open the Reading 1 menu.
3 Select on A. Observe that the
highlight jumps to the present
measurement.
4 Select the Hz measurement.
Observe that the top left of the screen displays the Hz
measurement. (See Figure 8.)
To choose also a Peak-Peak measurement for Input B as
second reading, do the following:
1 Display the SCOPE key labels.
2
Open the Reading 2 menu.
3
Select on B. The highlight jumps
to the measurements field.
4
Open the PEAK menu.
5
Select the Peak-Peak
measurement.