Fluke 192B - 196B/C - 199B/C
Users Manual
40
9
Select one of the Conditions:
and jump to Slope:.
10
Select the desired trigger slope,
and jump to Level:
11
Select the 0.12V or 1.2 V trigger
level and accept all recorder
options.
During recording samples are continuously saved in deep
memory. The last twelve recorded divisions are displayed
on the screen. Use View All to display the full memory
contents.
Note
To learn more about the Single Shot trigger
function, see Chapter 5 “Triggering on
Waveforms”.
Figure 21. Triggered Single Sweep Recording
Analyzing a TrendPlot or Scope Record
From a Scope TrendPlot or Scope Record you can use the
analysis functions CURSORS and ZOOM to perform
detailed waveform analysis. These functions are described
in Chapter 4: “Using Replay, Zoom and Cursors”.
To Next Page
Loading...
