Fluke 192B - 196B/C - 199B/C
Users Manual
48
Using Cursors on a A+B, A-B or A*B Waveform
Cursor measurements on a A*B waveform give a reading
in Watts if input A measures (milli)Volts and input B
measures (milli)Amperes.
For other cursor measurements on a A+B, A-B or A*B
waveform no reading will be available if the input A and
input B measurement unit are different.
Using Cursors on Spectrum Measurements
(C versions)
To do a cursor measurent on a spectrum, do the following:
1
From Spectrum measurement
display the cursor key label.
2
Move the cursor and observe the
readings at the top of the screen.
To Next Page
Loading...
