Fluke Ti480 - Image Capture and Saving; Focus Methods and Image Capture

Ti200, Ti300, Ti400, Ti450, Ti450SF6, Ti480
Users Manual
10
Focus
Correct focus makes sure that the infrared energy is correctly directed onto the pixels of the detector.
Without correct focus, the thermal image can be blurry and the radiometric data may be inaccurate.
Out-of-focus infrared images are frequently unusable or of little value.
To focus with the advanced manual focus system, rotate the Manual Focus Control until the inspection
object is in proper focus. Use the advanced manual focus system as an override to the LaserSharp
Auto Focus System. See LaserSharp Auto Focus System.
Capture Image
To capture an image:
1. Focus on a target.
2. Pull and release the Primary Trigger or double tap on the display to capture and freeze the image.
The image is in the memory buffer for you to save or edit the image. To edit an image, see Edit
Image.
Depending on the selected file format settings, the Imager shows the captured image and a menu
bar. The menu bar shows the available options.
Note
MultiSharp Focus captures and freezes images differently. See MultiSharp Focus.
Save Image
To save an image as a data file:
1. Capture an image.
The image is in the memory buffer for you to save or edit the image.
2. Push
 to save the image as a file and go back to the live view.
Menus
Use the menus to change and view settings.
To change settings:
1. Push
/ to select an option.
2. Push
 to set the option.
The primary, secondary, and option menus close 10 seconds after the last push of a function button.
The option selection menu stays open until you make the selection, go up a menu level, or cancel the
action.
When the Imager is in Gas Detection mode, some functions will be disabled. They will not be
selectable.