Fluke Ti480 - Spot Markers and Spot Box Setup; Setting Spot Markers Position; Setting Spot Box Size and Position

Thermal Imagers
Menus
15
Spot Markers
Use fixed-temperature spot markers to highlight a region on the display before you save an image.
To set a marker:
1. Select Measurement > Markers.
2. Select an option.
3. Push
 to set the marker option and go to the Move Marker display.
The Move Marker icon shows on the display and the labels on the function buttons change to Done,
Next, and Cancel.
To change the marker position on the display:
1. Push

/

/

/

to move the marker location on the image.
2. Push
 to select the next marker.
3. Repeat for the rest of the markers.
4. Push
 when done.
Spot Box
Use the Spot Box feature to adjust a temperature measurement zone (box) to center on the target. This
zone expands and contracts to different levels within the infrared image. The zone shows an
approximate maximum (MAX), average (AVG), and minimum (MIN) temperature measurement in that
area.
Note
When using the Spot Box, the level and span of the Imager adjusts to the thermal scene within
the Spot Box.
To set the size of the Spot Box when Spot Box is set to On:
1. Select Measurement > Spot Box > Set Size.
2. Push:
•

to decrease the vertical size of the Spot Box.
•

to increase the vertical size of the Spot Box.
•

to decrease the horizontal size of the Spot Box.
•

to increase the horizontal size of the Spot Box.
3. When you are satisfied with the size of the Spot Box, push
 to set the change and exit the
menus or push
 to set the change and go back to the previous menu.
To set the position of the Spot Box when Spot Box is set to On:
1. Select Measurement > Spot Box > Set Position.
2. Push

/

/

/

to move the Spot Box location on the image.
3. When satisfied with the position of the Spot Box, push
 to set the change and exit the menus or
push
 to set the change and go back to the previous menu.