Fluke Ti480 - Camera Menu

Thermal Imagers
Menus
21
Camera Menu
Table 12 lists the options in the Camera menu.
Table 12. Camera Menu
Option Menu Option Description
LaserSharp
Autofocus
On
Turns on LaserSharp Autofocus to automatically focus on a
target. See LaserSharp Auto Focus System.
Off
Turns off LaserSharp Autofocus to use the Advanced manual
focus. See LaserSharp Auto Focus System.
Backlight <options> Select to set the brightness level of the display.
Torch -- Turns on/off the built in flashlight.
Video
Video/Audio
Select to record video and audio when Record Video is
selected.
Video ONLY Select to record video only when Record Video is selected.
Record Video Select to start recording a video. See Video.
Auto Capture
Start Capture
Select to capture and save an infrared image, or series of
images based on Auto Capture settings.
Interval
Sets the number of hours, minutes, or seconds between image
captures.
Note
The minimum interval available can be affected by the file
type and visible light camera settings. Some combinations
create larger file sizes that take longer to capture and save
and create a higher minimum interval compared to others.
Image Count
Sets a number of images to capture. Or, select Maximum
Memory to capture and save images until the chosen storage
memory is full or the battery runs out of power.
Manual
Trigger
Select to immediately capture images when Start Capture is
selected.
Temp Trigger
Select to capture images when a value is above or below a set
temperature limit when Start Capture is selected.
Set Temp
Trigger
With Temp Trigger selected, set the temperature and conditions
to trigger the auto capture of images.