Fluke Ti480 - WiFi Hotspot and Network Connection; WiFi Hotspot Configuration; WiFi Network Connection Steps

Ti200, Ti300, Ti400, Ti450, Ti450SF6, Ti480
Users Manual
24
WiFi Hotspot
Use the Imager to create a wireless Hotspot when no WiFi network exists. You can use the Hotspot to
download saved pictures or stream live images from the Imager to a PC with SmartView software or to
a mobile device with the Fluke Connect app. See Stream Live to a PC and Fluke Connect Wireless
System for more information. When WiFi Hotspot is on,  shows in the upper left corner of the
display.
Note
WiFi is for indoor use only in Kuwait, Chile, and United Arab Emirates.
To create a Hotspot, select Camera > Wireless > WiFi Hotspot > On.
To change the settings:
1. Select Camera > Wireless > WiFi Hotspot > Off.
2. Select Settings.
3. Select an option:
• Name (SSID) to change the SSID
• Password to turn the password on/off or to change the password
• Channel to change the channel
4. Push
 to open a keyboard on the display.
5. Use the keyboard to enter the information for the option.
6. Push
 to go back.
7. Push
 to use the Imager.
WiFi Network
Use the WiFi Network setting to connect the Imager to a WiFi network and to sign into your Fluke
Connect account on the Imager. When WiFi Network is on,
 shows in the upper left corner of the
display.
To turn on the WiFi Network feature:
1. Select Camera > Wireless > WiFi Network > On.
2. Push Select to scan for available networks within range of the Imager.
3. Select a network.
4. Push
 to connect to or disconnect from a network.
5. If you are prompted, enter a password.