FT-5 User Manual Page 81
PRINTING SETTINGS
Printing settings determine the characteristics for an individual print. These settings include: print speed, fill density, shell thickness,
layer height, and other advanced settings. This section should be used as a guide to the different settings that may need to be
changed, and which settings should remain constant depending on your desired results.
PRINTING SETTING DEFINITIONS
Basic Settings
The parameters that are frequently adjusted to obtain the desire results for an individual part are found under the Basic
Setting tab in Cura. The figure below shows the typical Basic tab settings for most prints. A detailed explanation of each
parameter can be found below in the figure.
To Next Page
Loading...