TRAILER SWAY CONTROL
Note: This feature does not prevent trailer
sway, but reduces it once it begins.
Note: This feature cannot stop all trailers
from swaying.
Note: In some cases, if your vehicle speed
is too high, the system may turn on multiple
times, gradually reducing your vehicle speed.
This feature applies your vehicle brakes at
individual wheels and if necessary, reduces
engine power. If the trailer begins to sway,
the traction control warning lamp flashes
and a message will be shown in the
display. The first thing to do is slow your
vehicle down, then pull safely to the side
of the road and check for correct tongue
load and trailer load distribution. See Load
Carrying (page 120).
TOWING POINTS
WARNINGS
Switch the ignition off before
removing the towing hook. Failure to
do so could result in personal injury.
The towing hook may be hot. Take
care when removing it from the
engine compartment storage
location. Failure to do so could result in
personal injury.
The towing hook has a left-hand
thread. Turn it counterclockwise to
install it. Make sure that it is fully
tightened. Failure to do so could result in
the towing hook becoming loose.
Front Towing Point
Remove the cover and install the towing
hook.
Space is provided in the engine
compartment.
You must carry the towing hook in your
vehicle at all times.
126
Tourneo Custom/Transit Custom (TTF)
Towing
To Next Page
Loading...
