Open the rear doors. Remove the grommet
and fully insert the flat end of the wheel
brace or the short arm of the jack handle
into the socket. Turn counterclockwise
until the wheel rests on the ground and
there is slack in the cable.
1. Rotate the cable through 90 degrees.
2. Slide the cable through the slot to
release the spare wheel bracket from
the winch.
Unscrew the retaining nut to release the
spare wheel bracket.
Vehicle Jack
WARNINGS
You should only use the vehicle jack
supplied with your vehicle when
changing a wheel in emergency
situations.
Check the vehicle jack before use. It
should not be damaged or deformed,
and the thread lubricated and free
from foreign matter.
Never place anything between the
jack and the ground, or the jack and
your vehicle.
Note: Vehicles with a temporary mobility
kit do not have a vehicle jack or a wheel
brace. See Temporary Mobility Kit (page
164).
The jack, wheel brace and jack handle are
located in a storage compartment in the
front right stepwell.
170
Tourneo Custom/Transit Custom (TTF)
Wheels and Tires
To Next Page
Loading...
