1. Open the hood. See Opening and
Closing the Hood (page 145).
2. Remove the screws.
3. Push the headlamp toward the rear of
your vehicle and upward to disengage
it from its locating points.
4. Disconnect the electrical connector.
Note: When fitting the headlamp, make
sure that you reconnect the electrical
connector correctly.
Note: When fitting the headlamp, make
sure that you engage its locating points
correctly.
CHANGING A BULB
WARNINGS
Switch the lamps and the ignition off.
Failure to do so could result in
serious personal injury.
Bulbs can become hot, let the bulb
cool down before removing it. Failure
to do so could result in personal
injury.
Note: Only fit bulbs of the correct
specification.
Note: We recommended that you see an
authorized dealer to change the bulbs if your
vehicle is fitted with air conditioning. Some
bulbs are difficult to access.
Note: You will need to remove the
headlamp to change the headlamp, side
lamp, cornering lamp or front direction
indicator bulbs.
Note: The following instructions describe
how to remove the bulbs. Fit replacements
in the reverse order unless otherwise stated.
154
Tourneo Custom/Transit Custom (TTF)
Maintenance
To Next Page
Loading...
