FortiGate-200, FortiGate-300, FortiGate-400, FortiGate-500 and FortiGate-1000 FortiOS 3.0 MR4 Install Guide
20 01-30004-0267-20070215
Powering on the FortiGate unit Installing the FortiGate unit
Table 5: Technical specifications
Air Flow
• For rack installation, make sure the amount of air flow required for safe
operation of the FortiGate unit is not compromised
• For free-standing installation, make sure the FortiGate unit has at least 1.5 in.
(3.75 cm) of clearance on each side to allow for adequate air flow and cooling.
• If you install the FortiGate unit in a closed or multi-unit rack assembly, the
operating ambient temperature of the rack environment may be greater than
room ambient. Make sure the operating ambient temperature does not exceed
the manufacturer’s maximum rated ambient temperature.
Mechanical loading
For rack installation, make sure the mechanical loading of the FortiGate unit is
evenly distributed to avoid a hazardous condition.
Powering on the FortiGate unit
The FortiGate unit has an on/off switch.
To power on the FortiGate unit
1 Make sure the power switch on the back of the FortiGate unit is turned off.
2 Connect the power cable to the power connection on the back of the FortiGate
unit.
3 Connect the power cable to a power outlet.
4 Turn on the power switch.
Dimensions 16.75 x 12 x 1.75 in. (42.7 x 30.5 x 4.5 cm)
Weight 17.5 lb. (8 kg)
Power
requirements
Power dissipation: 285W (max.)
AC input voltage: 100 to 240VAC
AC input current: 6A
Frequency: 50 to 60Hz
• The FortiGate-1000 unit may overload your supply circuit and impact
your overcurrent protection and supply wiring. Use appropriate
equipment nameplate ratings to address this concern.
• Make sure the FortiGate-1000 unit has reliable grounding. Fortinet
recommends direct connection to the branch circuit.
Environmental
specifications
Operating temperature: 32 to 104 F (0 to 40 C)
Storage temperature: -13 to 158 F (-25 to 70 C)
Humidity: 5 to 95% non-condensing
To Next Page
Loading...
