FortiGate-200, FortiGate-300, FortiGate-400, FortiGate-500 and FortiGate-1000 FortiOS 3.0 MR4 Install Guide
30 01-30004-0267-20070215
Restoring the default settings Factory defaults
Restoring the default settings
You can revert to factory default settings and start over again if you mistakenly
change a network setting and are unable to recover from it.
Restoring the default settings using the web-based manager
To reset the default settings
1 Go to System > Status.
2 In the Unit Operation display, select Reset.
Restoring the default settings using the CLI
To reset the default settings enter the following command:
execute factoryreset
Caution: This procedure deletes all changes you have made to the FortiGate configuration
and reverses the system to its original configuration, including resetting interface
addresses.
Note: If you want to restore factory default settings using the front control buttons and LCD,
see “LCD front control buttons” on page 24.
To Next Page
Loading...
