Configuring the FortiGate unit Transparent mode installation
FortiGate-200, FortiGate-300, FortiGate-400, FortiGate-500 and FortiGate-1000 FortiOS 3.0 MR4 Install Guide
01-30004-0267-20070215 43
Transparent mode installation
This section describes how to install the FortiGate unit in Transparent mode. This
section includes the following topics:
• Preparing to configure Transparent mode
• Using the web-based manager
• Using the front control buttons and LCD
• Using the command line interface
• Connecting the FortiGate unit to your network
Preparing to configure Transparent mode
Use Table 16 on page 43 to gather the information you need to customize
Transparent mode settings.
You can configure Transparent mode using one of the following three methods:
• the web-based manager GUI
• the front control buttons and LCD
• the command line interface (CLI)
The method you choose depends on the complexity of the configuration, access
and equipment, and the type of interface you are most comfortable using.
Table 16: Transparent mode settings
Using the web-based manager
You can use the web-based manager to complete the initial configuration of the
FortiGate unit. You can continue to use the web-based manager for all FortiGate
unit settings.
For information about connecting to the web-based manager, see “Connecting to
the web-based manager” on page 22. The first time you connect to the FortiGate
unit, it is configured to run in NAT/Route mode.
To switch to Transparent mode using the web-based manager
1 Go to System > Status.
2 Select Change beside the Operation Mode.
3 Select Transparent.
4 Type the Management IP/Netmask address and the Default Gateway address you
gathered in Table 16 on page 43.
Administrator Password:
Management IP
IP: _____._____._____._____
Netmask: _____._____._____._____
Default Gateway: _____._____._____._____
The management IP address and netmask must be valid for the
network from which you will manage the FortiGate unit. Add a default
gateway if the FortiGate unit must connect to a router to reach the
management computer.
DNS Settings
Primary DNS Server: _____._____._____._____
Secondary DNS Server: _____._____._____._____
To Next Page
Loading...
