System Admin Monitoring administrators
FortiGate Version 4.0 Administration Guide
01-400-89802-20090424 229
http://docs.fortinet.com/ • Feedback
Monitoring administrators
To see the number of logged-in administrators, go to System > Status. Under System
Information, you will see Current Administrators. Select Details to view information about
the administrators currently logged in to the FortiGate unit.
Figure 119: System Information displaying current administrators
SSH Port TCP port to be used for administrative SSH access. The default is 22.
Enable SSH v1
compatibility
Enable compatibility with SSH v1 in addition to v2. (Optional)
Timeout Settings
Idle Timeout The number of minutes that an administrative connection can be idle
before the administrator must log in again. The maximum is 480
minutes (8 hours). To improve security, keep the idle timeout at the
default value of 5 minutes.
Display Settings
Language The language the web-based manager uses. Choose from English,
Simplified Chinese, Japanese, Korean, Spanish, Traditional Chinese
or French.
You should select the language that the management computer
operating system uses.
Lines per Page Number of lines per page to display in table lists. The default is 50.
Range is from 20 - 1000.
IPv6 Support on GUI Enable to configure IPv6 options from the GUI (Firewall policy, route,
address and address group). Default allows configuration from CLI
only.
Note: IPv6 is not supported in Transparent mode.
LCD Panel (LCD-equipped models only)
PIN Protection Select and enter a 6-digit PIN.
Administrators must enter the PIN to use the control buttons and LCD.
Enable SCP Enable users logged in through the SSH to be able to use the SCP to
copy the configuration file.
Note: If you make a change to the default port number for HTTP, HTTPS, Telnet, or SSH,
ensure that the port number is unique.
To Next Page
Loading...