Monitor User
FortiGate Version 4.0 Administration Guide
592 01-400-89802-20090424
http://docs.fortinet.com/ • Feedback
Figure 394: Firewall user monitor list
IPSEC monitor list
You can use the IPSEC monitor to view activity on IPSec VPN tunnels and start or stop
those tunnels. The display provides a list of addresses, proxy IDs, and timeout information
for all active tunnels, including tunnel mode and route-based (interface mode) tunnels.
You can use filters to control the information displayed in the list. For more information,
see “Adding filters to web-based manager lists” on page 53.
To view active tunnels, go to User > Monitor > IPSEC.
Refresh Refresh the Firewall user monitor list.
Current Page The current page number of list items that are displayed. Select the left and
right arrows to display the first, previous, next or last page of logged in users.
Column Settings Customize the table view. You can select the columns to hide or display and
specify the column displaying order in the table. For more information, see
“Using column settings to control the columns displayed” on page 58 and
“Web-based manager icons” on page 60.
Clear All Filters Remove all filters applied to the Firewall user monitor list.
De-authenticate All
Users
Stop authenticated sessions for all users in the Firewall user monitor list.
User(s) must re-authenticate with the firewall to resume their communication
session.
Filter icons Edit the column filters to filter or sort the firewall user monitor list according to
the criteria you specify. For more information, see “Adding filters to web-based
manager lists” on page 53.
User Name The user names of all connected remote users.
User Group The user group that the remote user is part of.
Duration Length of time since the user was authenticated.
Time-left Length of time remaining until the user session times out. Only available if the
authentication time of the session will be automatically extended
(authentication keepalive is enabled). If authentication keepalive is not
enabled, the value in Time-left will be N/A. For more information, see the
FortiGate CLI Reference.
IP Address The user’s source IP address.
Traffic Volume The amount of traffic through the FortiGate unit generated by the user.
Method Authentication method used for the user by the FortiGate unit (authentication
methods can be FSAE, firewall authentication, or NTLM).
Refresh
Stop individual
authentication session
Current Page
To Next Page
Loading...