System Status Topology
FortiGate Version 4.0 Administration Guide
01-400-89802-20090424 87
http://docs.fortinet.com/ • Feedback
Topology
The Topology page provides a way to diagram and document the networks connected to
your FortiGate unit.The Topology viewer is not available if Virtual Domains (VDOMs) are
enabled.
Go to System > Status > Topology to view the system topology. The Topology page
consists of a large canvas upon which you can draw a network topology diagram of your
FortiGate installation.
Figure 42: Topology page
Viewport and viewport control
The viewport displays only a portion of the drawing area. The viewport control, at the
bottom right of the topology page, represents the entire drawing area. The darker
rectangle represents the viewport. Drag the viewport rectangle within the viewport control
to determine which part of the drawing area the viewport displays.
The “+” and “-” buttons in the viewport control have the same function as the Zoom in and
Zoom out controls.
FortiGate unit object
The FortiGate unit is a permanent part of the topology diagram. You can move it, but not
delete it.
The FortiGate unit object shows the link status of the unit’s interfaces. Green indicates the
interface is up. Gray indicates the interface is down. Select the interface to view its IP
address and netmask, if assigned.
Text object
Zoom/Edit controls
Viewport
Viewport
control
FortiGate unit object
Subnet object
To Next Page
Loading...