Topology System Status
FortiGate Version 4.0 Administration Guide
88 01-400-89802-20090424
http://docs.fortinet.com/ • Feedback
Zoom and Edit controls
The toolbar at the top left of the Topology page shows controls for viewing and editing the
topology diagram.
Table 5: Zoom and Edit controls for Topology
Refresh the displayed diagram.
Zoom in. Select to display a smaller portion of the drawing area in
the viewport, making objects appear larger.
Zoom out. Select to display a larger portion of the drawing area in the
viewport, making objects appear smaller.
Select to begin editing the diagram.
This button expands the toolbar to show the editing controls
described below:
Save changes made to the diagram.
Note: If you switch to any other page in the web-based manager
without saving your changes, your changes are lost.
Add a subnet object to the diagram. The subnet object is based on
the firewall address that you select, and is connected by a line to the
interface associated with that address. See “Adding a subnet object”
on page 89.
Insert Text. Select this control and then click on the diagram where
you want to place the text object. Type the text and then click outside
the text box.
Delete. Select the object(s) to delete and then select this control or
press the Delete key.
Customize. Select to change the colors and the thickness of lines
used in the drawing. See “Customizing the topology diagram” on
page 90.
Drag. Select this control and then drag objects in the diagram to
arrange them.
Scroll. Select this control and then drag the drawing area
background to move the viewport within the drawing area. This has
the same effect as moving the viewport rectangle within the viewport
control.
Select. Select this control and then drag to create a selection
rectangle. Objects within the rectangle are selected when you
release the mouse button.
Exit. Select to finish editing the diagram. Save changes first.
The toolbar contracts to show only the Refresh and Zoom controls.
To Next Page
Loading...