Fortinet Gate 60D - PPTP Configuration Using CLI Commands

PPTP VPN PPTP configuration using CLI commands
FortiGate Version 4.0 Administration Guide
01-400-89802-20090424 549
http://docs.fortinet.com/ • Feedback
Figure 360: Edit PPTP range options, showing both Range and User Group
PPTP configuration using CLI commands
If you prefer not to set up a customized screen in the FortiGate web-based manager, you
can configure the PPTP tunnel using CLI.
Syntax
config vpn pptp
set eip <address_ipv4>
set ip-mode {range | usrgrp}
set local-ip <address_localip>
set sip <address_ipv4>
set status {disable | enable}
set usrgrp <group_name>
end
Enable PPTP Enable PPTP. You must add a user group before you can select the
option. See “User Group” on page 583.
IP Mode Select a method of determining the IP address for the PPTP connection:
Range Enable to specify a local address range to reserve for remote PPTP
clients.
User Group Select to specify that the PPTP client IP address is determined by the
PPTP user group server.
Starting IP Type the starting address in the range of reserved IP addresses.
Ending IP Type the ending address in the range of reserved IP addresses.
Local IP Type the IP address to be used for the peer’s remote IP on the PPTP
client side.
User Group Select the PPTP user group from the list.
Disable PPTP Select to disable PPTP support.
Variables Description Default
eip <address_ipv4> The ending address of the PPTP address range. 0.0.0.0