Fortinet Gate 60D - Multicast Policies; Viewing the Firewall Policy List

Firewall Policy Multicast policies
FortiGate Version 4.0 Administration Guide
01-400-89802-20090424 321
http://docs.fortinet.com/ • Feedback
To move a firewall policy in the firewall policy list
1 Go to Firewall > Policy.
2 In the firewall policy list, note the ID of a firewall policy that is before or after your
intended destination.
3 In the row corresponding to the firewall policy that you want to move, select the
Move To icon.
4 Select Before or After, and enter the ID of the firewall policy that is before or after your
intended destination. This specifies the policy’s new position in the firewall policy list.
5 Select OK.
Multicast policies
FortiGate units support multicast policies. You can configure and create multicast policies
using the following CLI command:
config firewall multicast-policy
For more information, see the FortiOS CLI Reference and the FortiGate Multicast
Technical Note.
Viewing the firewall policy list
The firewall policy list displays firewall policies in their order of matching precedence for
each source and destination interface pair.
If virtual domains are enabled on the FortiGate unit, firewall policies are configured
separately for each virtual domain; you must access the VDOM before you can configure
its policies. To access a VDOM, go to System > VDOM, and in the row corresponding to
the VDOM whose policies you want to configure, select Enter.
You can add, delete, edit, and re-order policies in the policy list. Firewall policy order
affects policy matching. For details about arranging policies in a policy list, see “How list
order affects policy matching” on page 319 and “Moving a policy to a different position in
the policy list” on page 320.
To view the policy list, go to Firewall > Policy.
Figure 191: Firewall policy list
Delete
Edit
Move To
Insert Policy before
Filter